MyBinding Standard 3030x Manuál s instrukcemi stáhnout pdf (Strana 31)

6.0 Operation

To unlink a job, use the up or down arrow key to point to the linked job name and press soft-key “C”

(Erase).

When finished entering send values you may exit the current job by pressing soft-key “B” (Job) to go

back to the job mode screen or soft-key “D” (Exit) to exit to send mode. Or you may use the current

job for cutting by pressing the down arrow at the last line and following the instructions in the Running

a Programmed Job section 6.13.6 below.

6.13.5 Editing an Existing Job

6.13.5.1 Editing the Job Name

The job name can be edited (or added if an existing job does not have a name) in the job mode

screen. To edit the name, move the cursor down to the desired job number by pressing the down

arrow key. Then press the right arrow key to move the cursor to the desired character position and

edit the character by pressing the up or down arrow keys to toggle between characters of the

alphabet. Numbers can be entered directly by using the number keys. Pressing CLEAR clears the

current character. When finished, you may either go to the current job by pressing ENTER, or go to a

different job, or exit job mode.

6.13.5.2 Editing Send Values

To edit send values of an existing job, start by opening the desired job from the job mode screen. A

job is opened by one of two methods: pointing at the desired job with the cursor and pressing

ENTER, or by entering the job number with the keypad and pressing ENTER. Once a job has been

opened, the current job number will be displayed in the upper right corner. Note: If the job is locked,

it cannot be edited.

Send values can now be edited by moving the cursor up or down to the desired send value and then

typing over the existing value.

When finished editing the job, you may exit the current job by pressing soft-key “B” (Job) to go back

to the job mode screen or soft-key “D” (Exit) to exit to send mode. Or you may use the job for cutting

since it is already open.

6.13.5.3 Inserting Send Values

To insert a send value, press the soft-key “A” (Insert). This moves all send values down and provides

a blank line after

the current send value. If more than 99 send values are needed, the job can be

linked (see Channel Linking under the Creating a New Job section on page 28).

6.13.5.4 Erasing Send Values

To erase a send value, press the soft-key “C” (Erase). This will remove the cut value currently being

pointed to by the cursor. To backspace over the current send value without removing the line, press

the left arrow key.

6.13.6 Running a Programmed Job

To use an existing job for cutting, you must first open it by using one of two methods: move the

cursor to the desired job with the arrow keys and press ENTER, or enter the job number with the

keypad and press ENTER. Once a job has been opened, the current job number will be displayed in

the upper right corner. Now press SEND to move the backgauge to the first programmed position (or

send value). Close the front guard and make a cut. Once the cut is made, the backgauge will

automatically push out the paper (if “push-out” is enabled) and move to the next programmed

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 77 78

Žádné komentáře

MyBinding Standard 3030x Manuál s instrukcemi Strana 31